HOW TO INSTALL HAZARD LIGHTS ON A MOTORBIKE/MOTORCYCLE/SCOOTER



A quick tutorial on how to fit hazard lights to your motorbike/scooter etc.
Parts needed.
1 flasher relay 2 or 3 pin.
1 dpst switch on/off i am using a on/off/on switch but not using one set of terminals.
1 10 amp inline fuse holder plus fuse.
Female spade connectors.
Roll of cable/red/black makes visualisation easy..
Some heat shrink tubing to add to the finished item.
REMEMBER X TERMINAL ON THE RELAY = 12 VOLT INPUT.
L TERMINAL ON RELAY = LOAD OUT TO SWITCH.
P TERMINAL ON RELAY TO THE PILOT LIGHTS ON DASH OF BIKE.

Fitted result http://youtu.be/7iGPFwB7LFU


Post time: Mar-29-2017